ZyXEL Communications GS2210-8 User Manual page 143

Figure 106 Advanced Applicat ion > Bandwidt h Cont rol
The following t able describes t he relat ed labels in t his screen.
Table 56 Advanced Applicat ion > Bandwidt h Cont rol
LABEL DESCRIPTION
Act ive Select t his check box t o enable bandwidt h cont rol on t he Swit ch.
Port This field displays t he port num ber.
* Set t ings in t his row apply t o all port s.
Use t his row only if you want t o m ake som e set t ings t he sam e for all port s. Use t his row first
t o set t he com m on set t ings and t hen m ake adj ust m ent s on a port- by- port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
Act ive Select t his check box t o act ivat e ingress rat e lim it s on t his port .
I ngress Rat e Specify t he m axim um bandwidt h allowed in kilobit s per second ( Kbps) for t he incom ing t raffic
flow on a port .
Note: Ingress rate bandwidth control applies to layer 2 traffic only.
Act ive Select t his check box t o act ivat e egress rat e lim it s on t his port .
Egress Rat e Specify t he m axim um bandwidt h allowed in kilobit s per second ( Kbps) for t he out- going t raffic
flow on a port .
Apply Click Apply t o save your changes t o t he Swit ch's run- t im e m em ory. The Swit ch loses t hese
changes if it is t urned off or loses power, so use t he Sa ve link on t he t op navigat ion panel t o
save your changes t o t he non- volat ile m em ory when you are done configuring.
Cancel Click Ca n ce l t o reset t he fields.
Chapter 14 Bandwidth Control
GS2210 Series User's Guide
143