ZyXEL Communications GS2210-8 User Manual page 263

Figure 185 Advanced Applicat ion > Layer 2 Prot ocol Tunneling
The following t able describes t he labels in t his screen.
Table 119 Advanced Applicat ion > Layer 2 Prot ocol Tunneling
LABEL DESCRIPTION
Act ive Select t his t o enable layer 2 prot ocol t unneling on t he Swit ch.
Dest inat ion Specify a MAC address wit h which t he Swit ch uses t o encapsulat e t he layer 2 prot ocol
MAC Address packet s by replacing t he dest inat ion MAC address in t he packet s.
Note: The MAC address can be either a unicast MAC address or multicast MAC address. If
you use a unicast MAC address, make sure the MAC address does not exist in the
address table of a switch on the service provider's network.
Note: All the edge switches in the service provider's network should be set to use the same
MAC address for encapsulation.
Port This field displays t he port num ber.
* Use t his row t o m ake t he set t ing t he sam e for all port s. Use t his row first and t hen m ake
adj ust m ent s on a port- by- port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
CDP Select t his opt ion t o have t he Swit ch t unnel CDP ( Cisco Discovery Prot ocol) packet s so t hat
ot her Cisco devices can be discovered t hrough t he service provider 's net work.
Chapter 28 Layer 2 Protocol Tunneling
GS2210 Series User's Guide
263