ZyXEL Communications GS2210-8 User Manual page 78

Figure 57 Basic Set t ing > PoE Set up
The following t able describes t he labels in t his screen.
Table 19 Basic Set t ing > PoE Set up
LABEL DESCRIPTION
PoE Mode Select t he power m anagem ent m ode you want t he Swit ch t o use.
• Cla ssifica t ion - Select t his if you want t he Swit ch t o reserve t he Max Power ( m W) t o
each PD according t o t he priorit y level. I f t he t ot al power supply runs out , PDs wit h lower
priorit y do not get power t o funct ion.
• Con su m pt ion - Select t his if you want t he Swit ch t o m anage t he t ot al power supply so
t hat each connect ed PD get s a resource. However, t he power allocat ed by t he Swit ch m ay
be less t han t he Max Power ( m W) of t he PD. PDs wit h higher priorit y also get m ore power
t han t hose wit h lower priorit y levels.
Port This is t he port index num ber.
* Set t ings in t his row apply t o all port s.
Use t his row only if you want t o m ake som e set t ings t he sam e for all port s. Use t his row first
t o set t he com m on set t ings and t hen m ake adj ust m ent s on a port- by- port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
PD Select t his t o provide power t o a PD connect ed t o t he port .
I f left unchecked, t he PD connect ed t o t he port cannot receive power from t he Sw it ch.
Chapter 8 Basic Setting
GS2210 Series User's Guide
78