Configuring Snmp User - ZyXEL Communications GS2210-8 User Manual

The following t able describes t he labels in t his screen.
Table 183 Managem ent > Access Cont rol > SNMP > Trap Group > Port
LABEL
Opt ion
Port
*
Act ive
Apply
Cancel

43.3.3 Configuring SNMP User

From t he SN M P screen, click Use r t o view t he screen as shown. Use t he Use r screen t o creat e
SNMP users for aut hent icat ion wit h m anagers using SNMP v3 and associat e t hem t o SNMP groups.
An SNMP user is an SNMP m anager.
Figure 259 Managem ent > Access Cont rol > SNMP > User
The following t able describes t he labels in t his screen.
Table 184 Managem ent > Access Cont rol > SNMP > User
LABEL
User I nform at ion
Usernam e
Chapter 43 Access Control
DESCRIPTION
Select t he t rap t ype you want t o configure here.
This field displays a port num ber.
Set t ings in t his row apply t o all port s.
Use t his row only if you want t o m ake som e of t he set t ings t he sam e for all port s. Use t his
row first t o set t he com m on set t ings and t hen m ake adj ust m ent s on a port- by- port basis.
Changes in t his row are copied t o all t he port s as soon as you m ake t hem .
Select t his check box t o enable t he t rap t ype of SNMP t raps on t his port .
Clear t his check box t o disable t he sending of SNMP t raps on t his port .
Click Apply t o save your changes t o t he Swit ch's run- t im e m em ory. The Swit ch loses
t hese changes if it is t urned off or loses power, so use t he Sa ve link on t he t op navigat ion
panel t o save your changes t o t he non- volat ile m em ory when you are done configuring.
Click Ca n ce l t o begin configuring t his screen afresh.
DESCRIPTION
Note: Use the username and password of the login accounts you specify in this screen to
create accounts on the SNMP v3 manager.
Specify t he usernam e of a login account on t he Swit ch.
GS2210 Series User's Guide
366