Lldp-Med Network Policy - ZyXEL Communications XS1930-12HP User Manual

Table 127 Advanced Application > LLDP > LLDP-MED Configuration
LABEL
Apply
Cancel

31.8 LLDP-MED Network Policy

Click Advanced Application > LLDP > LLDP-MED Network Policy (Click Here) to display the screen as
shown next.
Figure 180 Advanced Application > LLDP > LLDP-MED Network Policy
The following table describes the labels in this screen.
Table 128 Advanced Application > LLDP > LLDP-MED Network Policy
LABEL
Port
Application Type
Tag
VLAN
Chapter 31 Link Layer Discovery Protocol (LLDP)
DESCRIPTION
Click Apply to save the changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
DESCRIPTION
Enter the port number to set up the LLDP-MED network policy.
Select the type of application used in the network policy.
• voice
• voice-signaling
• guest-voice
• guest-voice-signaling
• softphone-voice
• video-conferencing
• streaming-video
• video-signaling
Select to tag or untag in the network policy.
• tagged
• untagged
Enter the VLAN ID number. It should be from 1 to 4094. For priority tagged frames, enter "0".
XS1930 Series User's Guide
253