Logging System Messages To The Pcmcia - Nortel 8300 Reference Manual

If the IP address you are attempting to configure is not reachable, the following
message is displayed:
Destination IP address not reachable !!! Could not configure.

Logging system messages to the PCMCIA

To begin logging system messages on the PCMCIA, use the following NNCLI
command from the Global Config mode:
logging logToPCMCIA
The following message is returned:
Logging to PCMCIA STARTED
Ending the logging of system messages on the PCMCIA
To discontinue logging system messages on the PCMCIA, use the following
NNCLI command from the Global Config mode:
no logging logToPCMCIA
The following message is returned:
Logging to PCMCIA STOPPED
Warning: Before removing the PCMCIA from your master CPU, you
must use the
no logging logToPCCard
Failure to do so can corrupt the file system on the PCMCIA and cause
your log file to be permanently lost.
Chapter 3 Setting up SMP logs using the NNCLI 37
System Messaging Platform Reference Guide
command to stop logging.