Nortel 8300 Reference Manual page 45

Message AcgId <value> ProfileId <value> cannot remove profile <value>
Severity ERROR
Description This message indicates that the template configuration in hardware could not be
cleared, Possible reasons for this are:
A.) The template does not exist in hardware.
B.) Template is still needed in the hardware.
Severity N/A
Action Try removing or enabling filters on the port.
Message AcgId <value> ProfileId <value> cannot UnBind ifIndex <value> <value>
Severity ERROR
Description This message indicates that the template configuration in hardware could not be
cleared for this port.
Synopsis N/A
Action Try removing or enabling filters on the port.
Message Acl Reference Count is <value> cannot be decremented for Act Id <value> acl
type <value>
Severity ERROR
Description Filter module's table management keeps dependency between ACL and ACT to
allow or prevent ACT modification or deletion.
Synopsis N/A
Action Check the dump using aclDumpActTbl(). Delete all the ACLs, ACTs and recreate
them.
Message aclAceListAdd() malloc() SIZE <value> FAIL
Severity ERROR
Description This message indicates that the system is low on resources.
Synopsis N/A
Action Reduce the running configuration or reboot.
Message aclAcgTblAdd() malloc() SIZE <value> FAIL
Severity ERROR
Description This message indicates the system is low on resources.
Synopsis N/A
Action Reduce the running configuration or reboot.
Chapter 4 SMP log error messages 45
System Messaging Platform Reference Guide