Nortel 8300 Reference Manual page 173

Message rcIpAddStaticArp: arpadd failed for failed
Severity ERROR
Description This message is generated if the addition of a static ARP entry in the ARP table
failed.
Synopsis Addition of static ARP table entry failed.
Action Contact customer support for further troubleshooting.
Message rcIpAddStaticArp: ipCircFromIFID failed
Severity ERROR
Description This message is generated when the circuit data is null for a given circuit ID.
Synopsis Getting semaphore failed.
Action Contact customer support for further troubleshooting.
Message rcIpAddStaticArpByPort: found an arp while adding the entry
Severity ERROR
Description This message indicates that an existing ARP entry was discovered while trying to
add the static ARP entry with the same IP address.
Synopsis N/A
Action Contact the customer support team if the problem persists.
Message rcIpAddStaticRoute: arpaddUnres returns NULL
Severity FATAL
Description This message is generated if system is not able to locate an entry in the
unresolved table.
Synopsis Search failed.
Action Contact customer service and have the following information available for further
analysis: system logs including any memory dumps, switch configuration, and
network topology.
Message rcIpAddStaticRtsByArp: could not find the specified nexthop
Severity ERROR
Description This message is generated when an ECMP path index for a non-local static route
is not equal to its maximum value.
Synopsis Value mismatch.
Action Check the configuration for the maximum value of the ECMP path index.
Chapter 4 SMP log error messages 173
System Messaging Platform Reference Guide