Nortel 8300 Reference Manual page 28

28 Chapter 2 Setting up SMP logs using the CLI
Table 6
show log file
followed by:
[category <value>]
[severity <value>]
[CPU <value>]
[save-to-file
<value>]
Configuration example
This configuration example uses commands listed in
all of the log messages generated by IP with severity levels of ERROR or
WARNING. The example also displays the log messages from the specified file
name, /pcmcia/sample.txt.
Example:
show log file name-of-file /pcmcia/sample.txt category IP severity
ERROR|WARNING cpu CPU3
316806-C
SMP log information (Sheet 2 of 2)
Filters and lists the logs (individually or combined)
according to category, severity, and the CPU that
generated it. Valid categories, CPUs, and severities are
listed in
Table 4 on page
Redirects the output to a file specified and removes all
encrypted information. The tail option is not supported
with the
to specify the destination file name, for example:
/pcmcia/newlog.txt.
Table 2 on page 18, Table 3 on page
19, respectively.
option. Replace <
save-to-file
Table 6 on page 27
18, and
>
value
to show