Nortel 8300 Reference Manual page 60

60 Chapter 4 SMP log error messages
Message Cannot configure card. Please remove and insert again
Severity ERROR
Description This message is generated to specify that card should be removed and then
re-inserted.
Synopsis Cannot configure card.
Action Contact Customer Support for further troubleshooting.
Message Cannot create logSendFatalLogTask task
Severity FATAL
Description The logSendFatalLogTask task cannot be created.
Synopsis N/A
Action Reboot the switch and contact the customer support team if the problem persists.
Message Cannot create message queue for radius snmp accounting Radius Snmp
acoounting not enabled
Severity ERROR
Description This message indicates the software resource for handling accounting messages
cannot be acquired.
Synopsis Software resource error
Action Contact customer support.
Message Cannot create TACACS+ client, maximum users reached
Severity ERROR
Description Software state machine error.
Synopsis A software error occurred, TACACS+ client should be operable. If proceeds,
contact technical support.
Action N/A
Message Cannot unbind BpduVlanId <value> from stg <value>, err=<value>!
Severity ERROR
Description This message indicates the unbinding of the STG from the BPDU VLAN failed in
hardware during STG deletion.
Synopsis N/A
Action Reboot the switch and contact the customer support team if the problem persists.
316806-C