Nortel 8300 Reference Manual page 48

48 Chapter 4 SMP log error messages
Message aclHwBuildProfileParamBlock(): ActEntry's AclType <value> is NOT
SUPPORTED
Severity WARNING
Description Two possible ACL types are IP, Non-IP. Any other value for the type field indicates
a corruption or incorrect information in the instrumentation table.
Synopsis N/A
Action Try removing or enabling filters on the port. Try a delete or create for the ACT. If
the ACT entry cannot be deleted, try a reboot. Check dump using
aclDumpActTbl().
Message aclHwBuildProfileParamBlock(): ActEntry's MatchInfo has unsupported field
<value> at index <value>
Severity WARNING
Description This message indicates the ACT entry has a field selection that could not be
handled correctly.
Synopsis N/A
Action Try removing or enabling filters on the port. Try a delete or create for the ACT. If
ACT entry cannot be deleted, try a reboot. Check dump using aclDumpActTbl().
Message aclHwBuildProfileParamBlock(): ActEntry's size <value> is corrupted/invalid
Severity WARNING
Description The size of the ACT entry is determined by the number of fields selected for each
ACL-type.
Synopsis N/A
Action Try removing or enabling filters on the port. Try a delete or create for the ACT. If
the ACT entry cannot be deleted, try a reboot. Check dump using
aclDumpActTbl().
Message aclHwCreateAction: Bridged/routed is NOT specified with remarking DSCP and
802.1p
Severity INFO
Description Remarking DSCP and 802.1p is supported for only one of the routed/bridged
traffic types in one rule. Thus, you must be sure to specify the routed/bridged
traffic-type in the rule.
Synopsis N/A
Action Try removing or enabling filters on the port. Try a delete or create for the ACG
from the port. Check remarking configuration. Dump using aclDumpAclTbl() or
aclDumpAceList().
316806-C