Nortel 8300 Reference Manual page 47

Message aclHwBuildPceParamBlock(): AclId <value> ProfileId <value> NOT FOUND
<value>
Severity ERROR
Description The template is expected in the hardware, but is not found.
Synopsis N/A
Action Try removing or enabling filters on the port. Try to delete or create for the ACG
from the port. Check dump using aclDumpAclTbl() or aclDumpAceList().
Message aclHwBuildPceParamBlock(): Pcl size <value> exceeding Max Pcl size <value>
for AclId <value>
Severity ERROR
Description Specified ACG required more than 128 filters in the hardware. This could result
from an attempt to use rules with conditional matching such as greater, less,
range, not-equal.
Synopsis N/A
Action Try to minimize the operators. If that does not help, remove some ACEs from the
ACLs.
Message aclHwBuildPceParamBlock(): Profile is corrupted # of Match fields exceeding limit
per Pce <value>
Severity WARNING
Description The hardware cannot support more than 16 bytes for each ACL type. A missing or
incomplete consistency check or corruption can cause this.
Synopsis N/A
Action Try removing or enabling filters on the port. Try to delete or create the Acg from
the port. Check dump using aclDumpAclTbl() or aclDumpAceList().
Message aclHwBuildPceParamBlock(): ProfileEntry's MatchInfo has unsupported field
<value> at index <value>
Severity WARNING
Description A rule in the ACL has a match field that could not be handled correctly.
Synopsis N/A
Action Try removing or enabling filters on the port. Try to delete or the ACG from the port.
Check dump using aclDumpAclTbl() or aclDumpAceList().
Chapter 4 SMP log error messages 47
System Messaging Platform Reference Guide