Product Safety Warnings And Information; Esd And Installation Caution Messages - Nortel 5500 Series Installation Manual

Step
1
2
3
4
5

Product safety warnings and information

The products described in this guide meet requirements of:
IEC 60950 3rd edition
CSA 22.2 No. 60950 3rd edition
UL 60950 3rd edition
EN60950 3rd edition
EN60825-1, +A11, +A2

ESD and installation caution messages

This section provides electrostatic discharge (ESD) and installation caution
messages.
This section provides electrostatic discharge (ESD) and installation caution
messages and translations.
Copyright © 2007–2010, Nortel Networks
.
Action
Remove dust or debris by blowing canned air into the optical port of
the device using the canned air extension tube.
Clean the optical port by inserting a wand moistened with alcohol
into the receptacle and rotating it.
Each cleaning wand should only be used to clean one optical port.
Dry the optical port by inserting a dry wand into the receptacle and
rotating it.
Do not let the IPA evaporate; wipe it dry immediately. Alcohols can leave
a residue that is difficult to remove.
Remove any lint by blowing compressed air into the optical port.
Reconnect the optical connector and check for proper function.
If you are not reinstalling the connector, be sure to use a protective
cap.
If problems persist, ensure that the connector or receptacle are not
damaged.
Nortel Ethernet Routing Switch 5500 Series
Installation — SFPs and XFPs
NN47200-302 01.04 Standard
5.1 27 January 2010
Product safety warnings and information 17
ATTENTION
—End—