Chapter 2: Setting Up Smp Logs Using The Cli - Nortel 8300 Reference Manual

Chapter 2
Setting up SMP logs using the CLI
This chapter includes the following topics that describe how to set up SMP logs
using CLI:
Topic
Displaying logs by file name, category, severity, and CPU
Defining transfer criteria for the log file
Configuring the remote host address and file name for log
transfer
Logging system messages to the PCMCIA
Stop logging system messages to the PCMCIA
Displaying logs by file name, category, severity, and CPU
To display log information by file name, category, severity, or CPU, enter the
following CLI command:
show log file [tail] [name-of-file <value>] [category
<value>] [severity <value>] [CPU <value>] [save-to-file
<value>]
Table 6
show log file
followed by:
[tail]
[name-of-file
<value>]
SMP log information (Sheet 1 of 2)
Displays the file from tail.
Displays the valid logs from the file name specified by
the user. This command cannot be used on the current
log file (the file into which the messages are currently
logged). Replace <
name, for example /pcmcia/logcopy.txt.
> to specify the source file
value
System Messaging Platform Reference Guide
27
Page
27
29
30
31
31