Configuring Static Ports - HP MSR ASM Configuration Manual

Step
4. Set the global aging timer for
dynamic member ports.
Setting the aging timers for the dynamic ports in a VLAN
Step
1. Enter system view.
2. Enter VLAN view.
3. Set the aging timer for the
dynamic router ports.
4. Set the aging timer for the
dynamic member ports.

Configuring static ports

If all hosts attached to a port are interested in the IPv6 multicast data addressed to a particular IPv6
multicast group, you can configure the port as a static member port for that IPv6 multicast group.
You can configure a port as a static router port, through which the switch can forward all IPv6 multicast
data that it received.
Configuration guidelines
• A static member port does not respond to queries from the MLD querier. When you configure a port
as a static member port or cancel this configuration on the port, the port does not send an
unsolicited MLD report or an MLD done message.
Static member ports and static router ports never age out. To remove such a port, use the
•
corresponding undo command.
Configuration procedure
To configure static ports:
Step
1. Enter system view.
2. Enter Layer 2 Ethernet
interface view or Layer 2
aggregate interface view or
enter port group view.
3. Configure the port as a static
member port.
4. Configure the port as a static
router port.
Command
host-aging-time interval
Command
system-view
vlan vlan-id
mld-snooping router-aging-time
interval
mld-snooping host-aging-time
interval
Command
system-view
•
Enter Layer 2 Ethernet interface
view or Layer 2 aggregate
interface view:
interface interface-type
interface-number
•
Enter port group view:
port-group manual
port-group-name
mld-snooping static-group
ipv6-group-address [ source-ip
ipv6-source-address ] vlan vlan-id
mld-snooping static-router-port
vlan vlan-id
394
Remarks
260 seconds by default.
Remarks
N/A
N/A
260 seconds by default.
260 seconds by default.
Remarks
N/A
Use either method.
No static member ports by default.
No static router ports by default.