Enabling Pim-Sm; Enabling Bidir-Pim - HP MSR ASM Configuration Manual

Enabling PIM-SM

Because BIDIR-PIM is implemented on the basis of PIM-SM, you must enable PIM-SM before enabling
BIDIR-PIM. To deploy a BIDIR-PIM domain, enable PIM-SM on all non-border interfaces of the domain.
IMPORTANT:
All interfaces on a device must be enabled with the same PIM mode.
Enabling PIM-SM globally for the public network
Step
1. Enter system view.
2. Enable IP multicast routing.
3. Enter interface view.
4. Enable PIM-SM.
Enabling PIM-SM for a VPN instance
Step
1. Enter system view.
2. Create a VPN instance and
enter VPN instance view.
3. Configure an RD for the VPN
instance.
4. Enable IP multicast routing.
5. Enter interface view.
6. Bind the interface with the
VPN instance.
7. Enable PIM-SM.

Enabling BIDIR-PIM

Perform this configuration on all routers in the BIDIR-PIM domain.
To enable BIDIR-PIM:
Command
system-view
multicast routing-enable
interface interface-type
interface-number
pim sm
Command
system-view
ip vpn-instance vpn-instance-name
route-distinguisher
route-distinguisher
multicast routing-enable
interface interface-type
interface-number
ip binding vpn-instance
vpn-instance-name
pim sm
72
Remarks
N/A
Disabled by default.
N/A
Disabled by default.
Remarks
N/A
N/A
For more information about this
command, see MPLS Command
Reference.
Not configured by default.
For more information about this
command, see MPLS Command
Reference.
Disabled by default.
N/A
By default, an interface belongs to
the public network, and is not
bound with any VPN instance.
For more information about this
command, see MPLS Command
Reference.
Disabled by default.