Configuring Static Ports; Enabling Igmp Snooping Fast-Leave Processing - HP 6125XLG Ip Multicast Configuration Manual

Setting the aging timers for the dynamic ports in a VLAN
Step
1. Enter system view.
2. Enter VLAN view.
3. Set the aging timer for the
dynamic router ports in the
VLAN.
4. Set the aging timer for the
dynamic member ports in the
VLAN.

Configuring static ports

You can configure a port as a static port for the following purposes:
To make all the hosts attached to the port receive multicast data for a multicast group, configure the
•
port as a static member port for the multicast group.
To make the Layer 2 device attached to the port forward all received multicast traffic on the port,
•
configure the port as a static router port.
You can also configure a port as a static router port, through which the switch can forward all the
multicast traffic it receives.
When you configure static ports, follow these guidelines:
A static member port does not respond to queries from the IGMP querier. When you configure a
•
port as a static member port or cancel this configuration on the port, the port does not send
unsolicited IGMP reports or IGMP leave messages.
Static member ports and static router ports never age out. To remove such a port, use the undo
•
igmp-snooping static-router-port or the undo igmp-snooping static-group command.
To configure static ports:
Step
1. Enter system view.
2. Enter Layer 2 Ethernet
interface view or Layer 2
aggregate interface view.
3. Configure the port as a static
member port.
4. Configure the port as a static
router port.

Enabling IGMP snooping fast-leave processing

The IGMP snooping fast-leave processing feature enables the switch to process IGMP leave messages
quickly. With this feature enabled, when the Layer 2 device receives an IGMP leave message on a port,
Command
system-view
vlan vlan-id
igmp-snooping router-aging-time
interval
igmp-snooping host-aging-time
interval
Command
system-view
interface interface-type
interface-number
igmp-snooping static-group
group-address [ source-ip
source-address ] vlan vlan-id
igmp-snooping static-router-port
vlan vlan-id
22
Remarks
N/A
N/A
The default setting is 260 seconds.
The default setting is 260 seconds.
Remarks
N/A
N/A
By default, a port is not a static
member port.
By default, a port is not a static
router port.