HP MSR ASM Configuration Manual page 361

Hash mask length: 128
State: Elected
Candidate RP: 1003::2(Pos5/2)
Priority: 192
HoldTime: 130
Advertisement Interval: 60
Next advertisement scheduled at: 00:00:48
# Display RP information on Router A.
[RouterA] display pim ipv6 rp-info
PIM-SM BSR RP information:
prefix/prefix length: FF0E::101/64
RP: 4002::1
Priority: 192
HoldTime: 130
Uptime: 00:05:19
Expires: 00:02:11
RP: 1003::2
Priority: 192
HoldTime: 130
Uptime: 00:05:19
Expires: 00:02:11
Assume that Host A needs to receive information addressed to IPv6 multicast group G (FF0E::100). The
RP corresponding to the multicast group G is Router E as result of hash calculation, so an RPT will be built
between Router A and Router E. When the multicast source S (4001::100/64) registers with the RP, an
SPT will be built between Router D and Router E. After receiving IPv6 multicast data, Router A
immediately switches from the RPT to the SPT. The routers on the RPT path (Router A and Router E) have
a (*, G) entry, and the routers on the SPT path (Router A and Router D) have an (S, G) entry. You can use
the display pim ipv6 routing-table command to display the PIM routing table information on the routers.
For example:
# Display IPv6 PIM multicast routing table information on Router A.
[RouterA] display pim ipv6 routing-table
Total 1 (*, G) entry; 1 (S, G) entry
(*, FF0E::100)
RP: 1003::2
Protocol: pim-sm, Flag: WC
UpTime: 00:03:45
Upstream interface: Pos5/0
Upstream neighbor: 1003::2
RPF prime neighbor: 1003::2
Downstream interface(s) information:
Total number of downstreams: 1
1: Ethernet1/1
Protocol: mld, UpTime: 00:02:15, Expires: 00:03:06
(4001::100, FF0E::100)
349