HP MSR ASM Configuration Manual page 209

Configuration procedure
1. Assign IP addresses and configure unicast routing:
a. Assign the IP address and subnet mask to each interface according to
shown.)
b. Configure OSPF on the routers in the PIM-SM domains to make sure the routers are
interoperable at the network layer and they can dynamically update routing information.
(Details not shown.)
2. Enable IP multicast routing, PIM-SM and IGMP, and configure a PIM domain border:
# On Router A, enable IP multicast routing, enable PIM-SM on each interface, and enable IGMP
on the host-side interface, Ethernet 1/1.
<RouterA> system-view
[RouterA] multicast routing-enable
[RouterA] interface ethernet 1/1
[RouterA-Ethernet1/1] igmp enable
[RouterA-Ethernet1/1] pim sm
[RouterA-Ethernet1/1] quit
[RouterA] interface serial 2/1
[RouterA-Serial2/1] pim sm
[RouterA-Serial2/1] quit
[RouterA] interface pos 5/1
[RouterA-Pos5/1] pim sm
[RouterA-Pos5/1] quit
[RouterA] interface loopback 0
[RouterA-LoopBack0] pim sm
[RouterA-LoopBack0] quit
# Enable IP multicast routing, PIM-SM, and IGMP on Router B, Router C and Router D in the same
way. (Details not shown.)
# Configure PIM domain borders on Router C.
[RouterC] interface pos 5/1
[RouterC-Pos5/1] pim bsr-boundary
[RouterC-Pos5/1] quit
[RouterC] interface pos 5/2
[RouterC-Pos5/2] pim bsr-boundary
[RouterC-Pos5/2] quit
[RouterC] interface serial 2/1
[RouterC-Serial2/1] pim bsr-boundary
[RouterC-Serial2/1] quit
# Configure PIM domain borders on Router A, Router B and Router D in the same way. (Details not
shown.)
3. Configure C-BSRs and C-RPs:
# Configure Loopback 0 on Router A as a C-BSR and a C-RP.
[RouterA] pim
[RouterA-pim] c-bsr loopback 0
[RouterA-pim] c-rp loopback 0
[RouterA-pim] quit
# Configure C-BSRs and C-RPs on Router C and Router D in the same way. (Details not shown.)
197
Figure 57. (Details not