HP MSR ASM Configuration Manual page 395

[RouterB-Ethernet1/2] quit
# Configure OSPFv3 on Router C.
[RouterC] ospfv3 1
[RouterC-ospfv3-1] router-id 3.3.3.3
[RouterC-ospfv3-1] quit
[RouterC] interface ethernet 1/1
[RouterC-Ethernet1/1] ospfv3 1 area 0
[RouterC-Ethernet1/1] quit
[RouterC] interface ethernet 1/2
[RouterC-Ethernet1/2] ospfv3 1 area 0
[RouterC-Ethernet1/2] quit
[RouterC] interface tunnel 0
[RouterC-Tunnel0] ospfv3 1 area 0
[RouterC-Tunnel0] quit
5. Enable IPv6 multicast routing, IPv6 PIM-DM, and MLD:
# On Router A, enable IPv6 multicast routing, and enable IPv6 PIM-DM on each interface.
[RouterA] multicast ipv6 routing-enable
[RouterA] interface ethernet 1/1
[RouterA-Ethernet1/1] pim ipv6 dm
[RouterA-Ethernet1/1] quit
[RouterA] interface ethernet 1/2
[RouterA-Ethernet1/2] pim ipv6 dm
[RouterA-Ethernet1/2] quit
[RouterA] interface tunnel 0
[RouterA-Tunnel0] pim ipv6 dm
[RouterA-Tunnel0] quit
# On Router C, enable IPv6 multicast routing, enable MLD on Ethernet 1/1, and enable IPv6
PIM-DM on each interface.
[RouterC] multicast ipv6 routing-enable
[RouterC] interface ethernet 1/1
[RouterC-Ethernet1/1] mld enable
[RouterC-Ethernet1/1] pim ipv6 dm
[RouterC-Ethernet1/1] quit
[RouterC] interface ethernet 1/2
[RouterC-Ethernet1/2] pim ipv6 dm
[RouterC-Ethernet1/2] quit
[RouterC] interface tunnel 0
[RouterC-Tunnel0] pim ipv6 dm
[RouterC-Tunnel0] quit
Verifying the configuration
The source sends the IPv6 multicast data to the IPv6 multicast group FF1E::101 and the receiver can
receive the IPv6 multicast data after joining the IPv6 multicast group. You can use the display pim ipv6
routing-table command to display IPv6 PIM routing table information on routers. For example:
# Display PIM routing table information on Router C.
[RouterC] display pim ipv6 routing-table
Total 1 (*, G) entry; 1 (S, G) entry
383