HP MSR ASM Configuration Manual page 231

[RouterA] interface pos 5/0
[RouterA-Pos5/0] pim sm
[RouterA-Pos5/0] quit
The configuration on Router B and Router D is similar to the configuration on Router A.
# Enable IP multicast routing on Router C, enable PIM-SM on each interface, and enable IGMP on
the host-side interface Ethernet 1/1.
<RouterC> system-view
[RouterC] multicast routing-enable
[RouterC] interface serial 2/0
[RouterC-Serial2/0] pim sm
[RouterC-Serial2/0] quit
[RouterC] interface serial 2/1
[RouterC-Serial2/1] pim sm
[RouterC-Serial2/1] quit
[RouterC] interface ethernet 1/1
[RouterC-Ethernet1/1] pim sm
[RouterC-Ethernet1/1] igmp enable
[RouterC-Ethernet1/1] quit
# Configure a PIM domain border on Router A.
[RouterA] interface pos 5/0
[RouterA-Pos5/0] pim bsr-boundary
[RouterA-Pos5/0] quit
# Configure a PIM domain border on Router B.
[RouterB] interface pos 5/0
[RouterB-Pos5/0] pim bsr-boundary
[RouterB-Pos5/0] quit
4. Configure C-BSRs and C-RPs:
# Configure the C-BSR and C-RP on Router A.
[RouterA] interface loopback 0
[RouterA-LoopBack0] ip address 1.1.1.1 32
[RouterA-LoopBack0] pim sm
[RouterA-LoopBack0] quit
[RouterA] pim
[RouterA-pim] c-bsr loopback 0
[RouterA-pim] c-rp loopback 0
[RouterA-pim] quit
# Configure the C-BSR and C-RP on Router B.
[RouterB] interface loopback 0
[RouterB-LoopBack0] ip address 2.2.2.2 32
[RouterB-LoopBack0] pim sm
[RouterB-LoopBack0] quit
[RouterB] pim
[RouterB-pim] c-bsr loopback 0
[RouterB-pim] c-rp loopback 0
[RouterB-pim] quit
5. Configure BGP, specify the MBGP peer and enable direct route redistribution:
219