HP MSR ASM Configuration Manual page 427

Figure 109 Network diagram
Configuration procedure
1. Assign an IP address and prefix length to each interface according to
shown.)
2. On Router A, enable IPv6 multicast routing, enable IPv6 PIM-DM on each interface, and enable
MLD on port Ethernet 1/1.
<RouterA> system-view
[RouterA] multicast ipv6 routing-enable
[RouterA] interface ethernet 1/1
[RouterA-Ethernet1/1] mld enable
[RouterA-Ethernet1/1] pim ipv6 dm
[RouterA-Ethernet1/1] quit
[RouterA] interface ethernet 1/2
[RouterA-Ethernet1/2] pim ipv6 dm
[RouterA-Ethernet1/2] quit
3. Configure Switch A:
# Enable MLD snooping globally.
<SwitchA> system-view
[SwitchA] mld-snooping
[SwitchA-mld-snooping] quit
# Create VLAN 100, assign ports Ethernet 1/1 through Ethernet 1/4 to this VLAN, and enable
MLD snooping and MLD snooping proxying in the VLAN.
[SwitchA] vlan 100
[SwitchA-vlan100] port ethernet 1/1 to ethernet 1/4
[SwitchA-vlan100] mld-snooping enable
[SwitchA-vlan100] mld-snooping proxying enable
[SwitchA-vlan100] quit
Verifying the configuration
After the configuration is completed, Host A and Host B send MLD join messages addressed to group
FF1E::101. When receiving the messages, Switch A sends a join message for the group out of Ethernet
1/1 (a router port) to Router A. Use the display mld-snooping group command and the display mld
415
Figure 109. (Details not