HP MSR ASM Configuration Manual page 364

Device
Router C
Router C
Router C
Router C
Router H
Router H
Router I
Router I
Configuration procedure
1. Configure the IPv6 address and prefix length for each interface according to
not shown.)
2. Configure OSPFv3 on the routers in the IPv6 PIM-SM domain to ensure network-layer reachability
among them. (Details not shown.)
3. Enable IPv6 multicast routing and IPv6 administrative scoping, and enable IPv6 PIM-SM and MLD:
# Enable IPv6 multicast routing and IPv6 administrative scoping on Router A, enable IPv6 PIM-SM
on each interface, and enable MLD on the host-side interface Ethernet 1/1.
<RouterA> system-view
[RouterA] multicast ipv6 routing-enable
[RouterA] pim ipv6
[RouterA-pim6] c-bsr admin-scope
[RouterA-pim6] quit
[RouterA] interface ethernet 1/1
[RouterA-Ethernet1/1] mld enable
[RouterA-Ethernet1/1] pim ipv6 sm
[RouterA-Ethernet1/1] quit
[RouterA] interface serial 2/1
[RouterA-Serial2/1] pim ipv6 sm
[RouterA-Serial2/1] quit
# Enable IPv6 multicast routing and IPv6 administrative scoping, and enable IPv6 PIM-SM and
MLD on Router E and Router I in the same way. (Details not shown.)
# On Router B, enable IPv6 multicast routing and IPv6 administrative scoping, and enable IPv6
PIM-SM on each interface.
<RouterB> system-view
[RouterB] multicast ipv6 routing-enable
[RouterB] pim ipv6
[RouterB-pim6] c-bsr admin-scope
[RouterB-pim6] quit
[RouterB] interface ethernet 1/1
[RouterB-Ethernet1/1] pim ipv6 sm
[RouterB-Ethernet1/1] quit
[RouterB] interface serial 2/1
[RouterB-Serial2/1] pim ipv6 sm
Interface IPv6 address
S2/1 3002::1/64
S2/2 3003::1/64
POS5/1 2002::2/64
POS5/2 3004::1/64
S2/1 4001::1/64
POS5/1 3004::2/64
Eth1/1 5001::1/64
S2/1 4001::2/64
Device
Router F
Router F
Router G
Router G
Source 1
Source 2
Source 3
—
352
Interface IPv6 address
POS5/1 6002::2/64
POS5/2 2003::2/64
Eth1/1 9001::1/64
S2/1 8001::2/64
— 2001::100/64
— 3001::100/64
— 9001::100/64
— —
Figure 97. (Details