Step
1.
Enter system view.
2.
Enter public network PIM view
or VPN instance PIM view.
3.
Configure an interface as a
C-BSR.
4.
Configure a legal BSR
address range.
Configuring a PIM domain border
As the administrative core of a PIM-SM domain, the BSR sends the collected RP-set information in the form
of bootstrap messages to all routers in the PIM-SM domain.
A PIM domain border is a bootstrap message boundary. Each BSR has its specific service scope. A
number of PIM domain border interfaces partition a network into different PIM-SM domains. Bootstrap
messages cannot cross a domain border in either direction.
Perform the following configuration on routers that you want to configure as a PIM domain border.
To configure a PIM domain border:
Step
1.
Enter system view.
2.
Enter interface view.
3.
Configure a PIM domain
border.
Configuring global C-BSR parameters
In each PIM-SM domain, a unique BSR is elected from C-BSRs. The C-RPs in the PIM-SM domain send
advertisement messages to the BSR. The BSR summarizes the advertisement messages to form an RP-set
and advertises it to all routers in the PIM-SM domain. All the routers use the same hash algorithm to get
the RP address that corresponds to specific multicast groups.
The following rules apply to the hash mask length and C-BSR priority:
•
You configure the hash mask length and C-BSR priority globally, in an admin-scoped zone, and in
the global-scoped zone.
The values configured in the global-scoped zone or admin-scoped zone have preference over the
•
global values.
If you do not configure these parameters in the global-scoped zone or admin-scoped zone, the
•
corresponding global values will be used.
For information about how to configure C-BSR parameters for an admin-scoped zone and global-scoped
zone, see
"Configuring C-BSRs for each admin-scoped zone and the global-scoped
Perform the following configuration on C-BSR routers.
To configure C-BSR parameters:
Command
system-view
pim [ vpn-instance
vpn-instance-name ]
c-bsr interface-type
interface-number [ hash-length
[ priority ] ]
bsr-policy acl-number
Command
system-view
interface interface-type
interface-number
pim bsr-boundary
65
Remarks
N/A
N/A
No C-BSRs are configured by
default.
Optional.
No restrictions on BSR address
range by default.
Remarks
N/A
N/A
By default, no PIM domain border
is configured.
zone."