Protocols And Standards; Mld Snooping Configuration Task List - HP MSR ASM Configuration Manual

Protocols and standards

RFC 4541, Considerations for Internet Group Management Protocol (IGMP) and Multicast Listener
Discovery (MLD) Snooping Switches

MLD snooping configuration task list

For the configuration tasks in this section, the following rules apply:
The configurations made in MLD-snooping view are effective for all VLANs. The configurations
•
made in VLAN view are effective for only the current VLAN. For a given VLAN, the configurations
made in MLD-snooping view are effective only if you do not make the same configuration in VLAN
view.
The configurations made in MLD-snooping view are effective for all ports. The configurations made
•
in Layer 2 Ethernet interface view or Layer 2 aggregate interface view are effective for only the
current port. The configurations made in port group view are effective for only the ports in the
current port group. For a given port, the configurations made in MLD-snooping view are effective
only if you do not make the same configuration in Layer 2 Ethernet interface view, Layer 2
aggregate interface view, or port group view.
• For MLD snooping, the configurations made on a Layer 2 aggregate interface do not interfere with
configurations made on its member ports, nor do they participate in aggregation calculations. A
configuration made on a member port of the aggregate group will take effect after the port leaves
the aggregate group.
Complete these tasks to configure MLD snooping in a VLAN:
Task
Configuring basic MLD
snooping functions
Configuring MLD snooping
port functions
Configuring MLD snooping
querier
Configuring MLD snooping
proxying
Configuring an MLD
snooping policy
Enabling MLD snooping
Specifying the version of MLD snooping
Configuring aging timers for dynamic ports
Configuring static ports
Configuring a port as a simulated member host
Enabling MLD snooping fast-leave processing
Disabling a port from becoming a dynamic router port
Enabling MLD snooping querier
Configuring parameters for MLD queries and responses
Configuring the source IPv6 addresses for MLD queries
Enabling MLD snooping proxying
Configuring the source IPv6 addresses for the MLD messages
sent by the proxy
Configuring an IPv6 multicast group filter
Configuring IPv6 multicast source port filtering
Enabling dropping unknown IPv6 multicast data
Enabling MLD report suppression
391
Remarks
Required.
Optional.
Optional.
Optional.
Optional.
Optional.
Optional.
Optional.
Optional.
Optional.
Optional.
Optional.
Optional.
Optional.
Optional.
Optional.