Configuring A Multicast Group Filter; Setting The Maximum Number Of Multicast Groups That An Interface Can Join - HP MSR ASM Configuration Manual

does not unsolicitedly send any IGMP report or IGMP leave message. In other words, the interface
is not a real member of the multicast group or the multicast source and group.
Configuration procedure
To configure an interface as a static member interface:
Step
1. Enter system view.
2. Enter interface view.
3. Configure the interface as a
static member interface.

Configuring a multicast group filter

To restrict the hosts on the network attached to an interface from joining certain multicast groups, you can
set an ACL rule on the interface as a packet filter. In this way, the interface maintains only the multicast
groups that match the criteria.
To configure a multicast group filter:
Step
1. Enter system view.
2. Enter interface view.
3. Configure a multicast group
filter.
Setting the maximum number of multicast groups that an
interface can join
This configuration only limits the number of multicast groups that are dynamically joined.
To configure the maximum number of multicast groups an interface can join:
Step
1. Enter system view.
2. Enter interface view.
3. Configure the maximum
number of multicast groups
that the interface can join.
Command
system-view
interface interface-type
interface-number
igmp static-group group-address
[ source source-address ]
Command
system-view
interface interface-type
interface-number
igmp group-policy acl-number
[ version-number ]
Command
system-view
interface interface-type
interface-number
igmp group-limit limit
23
Remarks
N/A
N/A
An interface is not a static member
of any multicast group or multicast
source and group by default.
Remarks
N/A
N/A
By default, no multicast group filter
is configured on this interface.
Namely, hosts on the current
interface can join any valid
multicast group. .
Remarks
N/A
N/A
The default value varies by device model.
For more information, see IP Multicast
Command Reference.