Step
2.
Enter MLD view.
3.
Enable MLD fast-leave
processing.
Enabling MLD fast-leave processing on an interface
Step
1.
Enter system view.
2.
Enter interface view.
3.
Enable MLD fast-leave
processing.
Enabling the MLD host tracking function
With the MLD host tracking function, the switch can record the information of the member hosts that are
receiving IPv6 multicast traffic, including the host IPv6 address, running duration, and timeout time. You
can monitor and manage the member hosts according to the recorded information.
Enabling the MLD host tracking function globally
Step
1.
Enter system view.
2.
Enter MLD view.
3.
Enable the MLD host tracking
function globally.
Enabling the MLD host tracking function on an interface
Step
1.
Enter system view.
2.
Enter interface view.
3.
Enable the MLD host tracking
function on the interface.
Configuring MLD SSM mapping
For some certain restrictions, some receiver hosts on an SSM network might run MLDv1. To provide SSM
service support for these receiver hosts, configure the MLD SSM mapping feature on the last-hop router.
Configuration prerequisites
Before you configure the MLD SSM mapping feature, complete the following tasks:
Command
mld
fast-leave [ group-policy
acl6-number ]
Command
system-view
interface interface-type
interface-number
mld fast-leave [ group-policy
acl6-number ]
Command
system-view
mld
host-tracking
Command
system-view
interface interface-type interface-number
mld host-tracking
283
Remarks
N/A
Disabled by default.
Remarks
N/A
N/A
Disabled by default.
Remarks
N/A
N/A
Disabled by default.
Remarks
N/A
N/A
Disabled by default.