PIM-DM configuration task list
Task
Enabling PIM-DM
Enabling state-refresh capability
Configuring state-refresh parameters
Configuring PIM-DM graft retry period
Configuring common PIM features
Configuration prerequisites
Before you configure PIM-DM, complete the following tasks:
Configure any unicast routing protocol so that all devices in the domain are interoperable at the
•
network layer.
Determine the interval between state-refresh messages.
•
•
Determine the minimum time to wait before receiving a new refresh message.
Determine the TTL value of state-refresh messages.
•
Determine the graft retry period.
•
Enabling PIM-DM
When PIM-DM is enabled, a router sends hello messages periodically to discover PIM neighbors and
processes messages from the PIM neighbors. When you deploy a PIM-DM domain, enable PIM-DM on
all non-border interfaces of the routers.
PIM-DM does not work with multicast groups in the SSM group range.
IMPORTANT:
All the interfaces on a device must operate in the same PIM mode.
Enabling PIM-DM globally on the public network
Step
1.
Enter system view.
2.
Enable IP multicast routing.
3.
Enter interface view.
4.
Enable PIM-DM.
Enabling PIM-DM in a VPN instance
Step
1.
Enter system view.
Remarks
Required.
Optional.
Optional.
Optional.
Optional.
Command
system-view
multicast routing-enable
interface interface-type
interface-number
pim dm
Command
system-view
57
Remarks
N/A
Disabled by default.
N/A
Disabled by default.
Description
N/A