HP MSR ASM Configuration Manual page 50

Figure 17 Network diagram
Configuration procedure
1. Assign an IP address and subnet mask to each interface according to
shown.)
2. Enable IP multicast routing, PIM-DM, IGMP, and IGMP proxying:
# Enable IP multicast routing on Router A, PIM-DM on Serial 2/1, and IGMP on Ethernet 1/1.
<RouterA> system-view
[RouterA] multicast routing-enable
[RouterA] interface serial 2/1
[RouterA-Serial2/1] pim dm
[RouterA-Serial2/1] quit
[RouterA] interface ethernet 1/1
[RouterA-Ethernet1/1] igmp enable
[RouterA-Ethernet1/1] pim dm
[RouterA-Ethernet1/1] quit
# Enable IP multicast routing on Router B, IGMP proxying on Ethernet 1/1, and IGMP on Ethernet
1/2.
<RouterB> system-view
[RouterB] multicast routing-enable
[RouterB] interface ethernet 1/1
[RouterB-Ethernet1/1] igmp proxying enable
[RouterB-Ethernet1/1] quit
[RouterB] interface ethernet 1/2
[RouterB-Ethernet1/2] igmp enable
[RouterB-Ethernet1/2] quit
Verifying the configuration
# Display the IGMP configuration and operation information on Ethernet 1/1 of Router B.
[RouterB] display igmp interface ethernet 1/1 verbose
Ethernet1/1(192.168.1.2):
IGMP proxy is enabled
Current IGMP version is 2
Multicast routing on this interface: enabled
Require-router-alert: disabled
Version1-querier-present-timer-expiry: 00:00:20
38
Figure 17. (Details not