HP MSR ASM Configuration Manual page 394

2. Configure the IP address and prefix length for each interface as shown in
shown.)
3. Configure a GRE tunnel:
# On Router A, create interface Tunnel 0 and assign an IPv6 address and prefix length to it.
<RouterA> system-view
[RouterA] interface tunnel 0
[RouterA-Tunnel0] ipv6 address 5001::1 64
# On Router A, specify the tunnel encapsulation mode as GRE over IPv6, and specify its source
and destination addresses.
[RouterA-Tunnel0] tunnel-protocol gre ipv6
[RouterA-Tunnel0] source 2001::1
[RouterA-Tunnel0] destination 3001::2
[RouterA-Tunnel0] quit
# On Router C, create interface Tunnel 0 and assign an IPv6 address and prefix length to it.
<RouterC> system-view
[RouterC] interface tunnel 0
[RouterC-Tunnel0] ipv6 address 5001::2 64
# # On Router C, specify the tunnel encapsulation mode as GRE over IPv6, and specify its source
and destination addresses.
[RouterC-Tunnel0] tunnel-protocol gre
[RouterC-Tunnel0] source 3001::2
[RouterC-Tunnel0] destination 2001::1
[RouterC-Tunnel0] quit
4. Configure OSPFv3:
# Configure OSPFv3 on Router A.
[RouterA] ospfv3 1
[RouterA-ospfv3-1] router-id 1.1.1.1
[RouterA-ospfv3-1] quit
[RouterA] interface ethernet 1/1
[RouterA-Ethernet1/1] ospfv3 1 area 0
[RouterA-Ethernet1/1] quit
[RouterA] interface ethernet 1/2
[RouterA-Ethernet1/2] ospfv3 1 area 0
[RouterA-Ethernet1/2] quit
[RouterA] interface tunnel 0
[RouterA-Tunnel0] ospfv3 1 area 0
[RouterA-Tunnel0] quit
# Configure OSPFv3 on Router B.
<RouterB> system-view
[RouterB] ospfv3 1
[RouterB-ospfv3-1] router-id 2.2.2.2
[RouterB-ospfv3-1] quit
[RouterB] interface ethernet 1/1
[RouterB-Ethernet1/1] ospfv3 1 area 0
[RouterB-Ethernet1/1] quit
[RouterB] interface ethernet 1/2
[RouterB-Ethernet1/2] ospfv3 1 area 0
382
Figure 102. (Details not