HP MSR ASM Configuration Manual page 122

Configuration procedure
1. Assign IP addresses and configure unicast routing:
a. Assign an IP address and subnet mask to each interface according to
shown.)
b. Configure OSPF on the routers in the PIM-SSM domain to make sure they are interoperable at
the network layer. (Details not shown.)
2. Enable IP multicast routing, and enable PIM-SM and IGMP:
# Enable IP multicast routing on Router A, enable PIM-SM on each interface, and run IGMPv3 on
Ethernet 1/1, which connects Router A to the stub network.
<RouterA> system-view
[RouterA] multicast routing-enable
[RouterA] interface ethernet 1/1
[RouterA-Ethernet1/1] igmp enable
[RouterA-Ethernet1/1] igmp version 3
[RouterA-Ethernet1/1] pim sm
[RouterA-Ethernet1/1] quit
[RouterA] interface serial 2/0
[RouterA-Serial2/0] pim sm
[RouterA-Serial2/0] quit
[RouterA] interface pos 5/0
[RouterA-Pos5/0] pim sm
[RouterA-Pos5/0] quit
# Enable IP multicast routing, PIM-SM, and IGMP on Router B and Router C in the same way.
(Details not shown.)
# Enable IP multicast routing and PIM-SM on Router D and Router E in the same way. (Details not
shown.)
3. Configure the SSM group range:
# Configure the SSM group range to be 232.1.1.0/24 on Router A.
[RouterA] acl number 2000
[RouterA-acl-basic-2000] rule permit source 232.1.1.0 0.0.0.255
[RouterA-acl-basic-2000] quit
[RouterA] pim
[RouterA-pim] ssm-policy 2000
[RouterA-pim] quit
# Configure the SSM group range to be 232.1.1.0/24 on Router B, Router C, Router D and Router
E in the same way. (Details not shown.)
Verifying the configuration
Use the display pim interface command to display the PIM information on each interface. For example:
# Display PIM configuration information on Router A.
[RouterA] display pim interface
VPN-Instance: public net
Interface
Eth1/1
Ser2/0
Pos5/0
NbrCnt HelloInt DR-Pri
0 30 1
1 30 1
1 30 1
110
Figure
DR-Address
10.110.1.1 (local)
192.168.1.2
192.168.9.2
35. (Details not