Task
Reset PIM control message
counters.
PIM configuration examples
This section provides examples of configuring PIM on routers.
PIM-DM configuration example
Network requirements
As shown in
different organizations form stub networks, and one or more receiver hosts exist in each stub network. The
entire PIM domain operates in the dense mode.
Host A and Host C are multicast receivers in two stub networks N1 and N2.
IGMPv2 runs between Router A and N1 and between Router B, Router C, and N2.
Figure 31 Network diagram
Source
10.110.5.100/24
Table 8
shows the interface and IP address assignment, and network topology scheme.
Table 8 Interface and IP address assignment
Device
Router A
Router A
Command
reset pim [ all-instance | vpn-instance
vpn-instance-name ] control-message counters
[ interface interface-type interface-number ]
Figure
31, the receivers receive VOD information through multicast. The receiver groups of
Eth1/1
POS5/0
Router D
PIM-DM
Interface
Ethernet 1/1
Serial 2/0
Router A
Eth1/1
POS5/0
Eth1/1
Router B
Eth1/1
Router C
IP address
10.110.1.1/24
192.168.1.1/24
89
Remarks
Available in user
view.
Receiver
Host A
Host B
Receiver
Host C
Host D