HP MSR ASM Configuration Manual page 205

[RouterB-LoopBack10] quit
[RouterB] interface loopback 20
[RouterB-LoopBack20] pim sm
[RouterB-LoopBack20] quit
# Enable IP multicast routing, and enable PIM-SM and IGMP on Router A, Router C, Router D, and
Router E in the same way. (Details not shown.)
3. Configure C-BSRs and C-RPs:
# Configure Loopback 10 as a C-BSR and configure Loopback 20 as a C-RP on Router B.
[RouterB] pim
[RouterB-pim] c-bsr loopback 10
[RouterB-pim] c-rp loopback 20
[RouterB-pim] quit
# Configure a C-BSR and a C-RP on Router D in the same way (Details not shown).
4. Configure MSDP peers:
# Configure an MSDP peer on Loopback 0 of Router B.
[RouterB] msdp
[RouterB-msdp] originating-rp loopback 0
[RouterB-msdp] peer 2.2.2.2 connect-interface loopback 0
[RouterB-msdp] quit
# Configure an MSDP peer on Loopback 0 of Router D.
[RouterD] msdp
[RouterD-msdp] originating-rp loopback 0
[RouterD-msdp] peer 1.1.1.1 connect-interface loopback 0
[RouterD-msdp] quit
Verifying the configuration
# Display brief information about MSDP peers on Router B.
[RouterB] display msdp brief
MSDP Peer Brief Information of VPN-Instance: public net
Configured
1
Peer's Address
2.2.2.2
# Display brief information about MSDP peers on Router D.
[RouterD] display msdp brief
MSDP Peer Brief Information of VPN-Instance: public net
Configured
1
Peer's Address
1.1.1.1
When Source 1 (10.1 10.5.100/24) sends multicast data to multicast group G (225.1.1.1), Host A joins
multicast group G. By comparing the PIM routing information displayed on Router B with that displayed
on Router D, you can see that Router B acts now as the RP for Source 1 and Host A.
# Display PIM routing information on Router B.
Up Listen
1 0
State Up/Down time
Up 00:10:17
Up Listen
1 0
State Up/Down time
Up 00:10:18
Connect Shutdown
0 0
AS SA Count
? 0
Connect Shutdown
0 0
AS SA Count
? 0
193
Down
0
Reset Count
0
Down
0
Reset Count
0