HP MSR ASM Configuration Manual page 365

[RouterB-Serial2/1] quit
[RouterB] interface pos 5/1
[RouterB-Pos5/1] pim ipv6 sm
[RouterB-Pos5/1] quit
[RouterB] interface pos 5/2
[RouterB-Pos5/2] pim ipv6 sm
[RouterB-Pos5/2] quit
# Enable IPv6 multicast routing and IPv6 administrative scoping, and enable IPv6 PIM-SM on
Router C, Router D, Router F, Router G, and Router H in the same way. (Details not shown.)
4. Configure an IPv6 admin-scoped zone boundary:
# On Router B, configure POS 5/1 and POS 5/2 as the boundary of IPv6 admin-scoped zone 1.
[RouterB] interface pos 5/1
[RouterB-Pos5/1] multicast ipv6 boundary scope 4
[RouterB-Pos5/1] quit
[RouterB] interface pos 5/2
[RouterB-Pos5/2] multicast ipv6 boundary scope 4
[RouterB-Pos5/2] quit
# On Router C, configure POS 5/1 and POS 5/2 as the boundary of IPv6 admin-scoped zone 2.
<RouterC> system-view
[RouterC] interface pos 5/1
[RouterC-Pos5/1] multicast ipv6 boundary scope 4
[RouterC-Pos5/1] quit
[RouterC] interface pos 5/2
[RouterC-Pos5/2] multicast ipv6 boundary scope 4
[RouterC-Pos5/2] quit
# On Router D, configure POS 5/1 as the boundary of admin-scoped zone 2.
<RouterD> system-view
[RouterD] interface pos 5/1
[RouterD-Pos5/1] multicast ipv6 boundary scope 4
[RouterD-Pos5/1] quit
5. Configure C-BSRs and C-RPs:
# On Router B, configure the service scope of RP advertisements and configure Serial 2/1 as a
C-BSR and C-RP of admin-scoped zone 1.
[RouterB] pim ipv6
[RouterB-pim6] c-bsr scope 4
[RouterB-pim6] c-bsr 1002::2
[RouterB-pim6] c-rp 1002::2 scope 4
[RouterB-pim6] quit
# On Router D, configure the service scope of RP advertisements and configure Serial 2/1 as a
C-BSR and C-RP of admin-scoped zone 2.
[RouterD] pim ipv6
[RouterD-pim6] c-bsr scope 4
[RouterD-pim6] c-bsr 3002::2
[RouterD-pim6] c-rp 3002::2 scope 4
[RouterD-pim6] quit
# On Router F, configure Serial 2/1 as a C-BSR and C-RP in the global-scoped zone.
<RouterF> system-view
353