Table of Contents
Advertisement
Step
1.
Enter system view.
2.
Enter VLAN view.
3.
Configure the source IPv6
address for MLD general
queries.
4.
Configure the source IPv6
address for MLD
multicast-address-specific
queries.
Configuring MLD snooping proxying
This section describes how to configure MLD snooping proxying.
Configuration prerequisites
Before you configure MLD snooping proxying in a VLAN, complete the following tasks:
Enable MLD snooping in the VLAN.
•
•
Determine the source IPv6 address for the MLD reports sent by the proxy.
Determine the source IPv6 address for the MLD done messages sent by the proxy.
•
Enabling MLD snooping proxying
The MLD snooping proxying function works on a per-VLAN basis. After you enable the function in a
VLAN, the device works as the MLD snooping proxy for the downstream hosts and upstream router in the
VLAN.
To enable MLD snooping proxying in a VLAN:
Step
1.
Enter system view.
2.
Enter VLAN view.
3.
Enable MLD snooping
proxying in the VLAN.
Configuring the source IPv6 addresses for the MLD messages
sent by the proxy
You can set the source IPv6 addresses of the MLD reports and done messages that the MLD snooping
proxy sends on behalf of its attached hosts.
To configure the source IPv6 addresses of MLD messages that the MLD snooping proxy sends in a VLAN:
Command
system-view
vlan vlan-id
mld-snooping general-query
source-ip { ipv6-address |
current-interface }
mld-snooping special-query
source-ip { ipv6-address |
current-interface }
Command
system-view
vlan vlan-id
mld-snooping proxying enable
399
Remarks
N/A
N/A
FE80::02FF:FFFF:FE00:0001 by
default.
FE80::02FF:FFFF:FE00:0001 by
default.
Remarks
N/A
N/A
Disabled by default.
Advertisement
Table of Contents
Troubleshooting
