HP MSR ASM Configuration Manual page 385

Solution
1. Use the display ipv6 routing-table command to verify that routes to the RP and the BSR are
available on each router, and that a route between the RP and the BSR is available. Make sure
each C-RP has a unicast route to the BSR, the BSR has a unicast route to each C-RP, and all the
routers in the entire network have a unicast route to the RP.
2. IPv6 PIM-SM needs the support of the RP and BSR. Use the display pim ipv6 bsr-info command to
verify that the BSR information exists on each router, and then use the display pim ipv6 rp-info
command to verify that the RP information is correct on each router.
3. Use the display pim ipv6 neighbor command to verify that normal neighboring relationship has
been established among the routers.
373