Msdp Configuration Task List; Configuring Basic Msdp Functions; Configuration Prerequisites; Enabling Msdp - HP MSR ASM Configuration Manual

MSDP configuration task list

Task
Configuring basic MSDP
functions
Configuring an MSDP peer
connection
Configuring SA message
related parameters

Configuring basic MSDP functions

All the configuration tasks should be performed on RPs in PIM-SM domains, and each of these RPs acts
as an MSDP peer.

Configuration prerequisites

Before you configure basic MSDP functions, complete the following tasks:
Configure any unicast routing protocol so that all devices in the domain are interoperable at the
•
network layer.
• Configure PIM-SM to enable intra-domain multicast forwarding.
Determine the IP addresses of MSDP peers.
•
Determine the address prefix list for an RP address filtering policy.
•

Enabling MSDP

This section describes how to enable MSDP.
Enabling MSDP globally for the public network
Step
1. Enter system view.
Enable IP multicast routing.
2.
3. Enable MSDP and enter
public network MSDP view.
Enabling MSDP
Creating an MSDP peer connection
Configuring a static RPF peer
Configuring MSDP peer description
Configuring an MSDP mesh group
Configuring MSDP peer connection control
Configuring SA message content
Configuring SA request messages
Configuring SA message filtering rules
Configuring the SA cache mechanism
Command
system-view
multicast routing-enable
msdp
174
Remarks
Required.
Required.
Optional.
Optional.
Optional.
Optional.
Optional.
Optional.
Optional.
Optional.
Remarks
N/A
Disabled by default.
Disabled by default.