Mld Ssm Mapping Configuration Example - HP MSR ASM Configuration Manual

Ip multicast
Table of Contents

Advertisement

[RouterB-Pos5/0] pim ipv6 dm
[RouterB-Pos5/0] quit
# Enable IPv6 multicast routing on Router C, enable IPv6 PIM-DM on each interface, and enable
MLD on the host-side interface Ethernet 1/1.
<RouterC> system-view
[RouterC] multicast ipv6 routing-enable
[RouterC] interface ethernet 1/1
[RouterC-Ethernet1/1] mld enable
[RouterC-Ethernet1/1] pim ipv6 dm
[RouterC-Ethernet1/1] quit
[RouterC] interface pos 5/0
[RouterC-Pos5/0] pim ipv6 dm
[RouterC-Pos5/0] quit
3.
Configure an IPv6 multicast group filter on Router A, so that the hosts connected to Ethernet 1/1
can join IPv6 multicast group FF1E::101 only.
[RouterA] acl ipv6 number 2001
[RouterA-acl6-basic-2001] rule permit source ff1e::101 128
[RouterA-acl6-basic-2001] quit
[RouterA] interface ethernet 1/1
[RouterA-Ethernet1/1] mld group-policy 2001
[RouterA-Ethernet1/1] quit
Verifying the configuration
# Display MLD information on Ethernet 1/1 of Router B.
[RouterB] display mld interface ethernet 1/1
Ethernet1/1(FE80::200:5EFF:FE66:5100):
MLD is enabled
Current MLD version is 1
Value of query interval for MLD(in seconds): 125
Value of other querier present interval for MLD(in seconds): 255
Value of maximum query response time for MLD(in seconds): 10
Querier for MLD: FE80::200:5EFF:FE66:5100 (this router)
Total 1 MLD Group reported

MLD SSM mapping configuration example

Network requirements
As shown in
multicast delivery. Router D's Ethernet 1/3 serves as the C-BSR and C-RP. The SSM group range is
FF3E::/64.
MLDv2 runs on Router D's Ethernet 1/1. The receiver host runs MLDv1, and does not support MLDv2.
Therefore, the Receiver host cannot specify expected multicast sources in its membership reports.
Source 1, Source 2, and Source 3 send IPv6 multicast packets to multicast groups in the IPv6 SSM group
range. You can configure the MLD SSM mapping feature on Router D so that the receiver host will receive
IPv6 multicast data from Source 1 and Source 3 only.
Figure
80, the IPv6 PIM-SM domain applies both the ASM model and SSM model for IPv6
289

Advertisement

Table of Contents
loading

This manual is also suitable for:

Msr sfmMsr ssm

Table of Contents