Configuring Static Ports - HP MSR1002-4 Configuration Manual

•
If a dynamic router port receives a PIMv2 hello message, the aging timer for the port is specified
by the hello message. In this case, the router-aging-time or igmp-snooping
router-aging-time command does not take effect on the port.
•
IGMP group-specific queries originated by the Layer 2 device trigger the adjustment of aging
timers for dynamic member ports. If a dynamic member port receives such a query, its aging
timer is set to twice the IGMP last member query interval. For more information about setting
the IGMP last member query interval on the Layer 2 device, see "Setting the IGMP last member
query interval."
•
You can set the timers globally for all VLANs in IGMP-snooping view or for a VLAN in VLAN
view. For a VLAN, the VLAN-specific configuration takes priority over the global configuration.
Setting the aging timers for dynamic ports globally
Step
1. Enter system view.
2. Enter IGMP-snooping view.
3. Set the aging timer for
dynamic
globally.
4. Set the global aging timer for
dynamic
globally.
Setting the aging timers for dynamic ports in a VLAN
Step
1. Enter system view.
2. Enter VLAN view.
3. Set the aging timer for
dynamic router ports in the
VLAN.
4. Set the aging timer for
dynamic member ports in the
VLAN.

Configuring static ports

You can configure the following types of static ports:
•
Static member port—When you configure a port as a static member port for a multicast group,
all hosts attached to the port will receive multicast data for the group.
The static member port does not respond to IGMP queries. When you complete or cancel this
configuration on a port, the port does not send an unsolicited IGMP report or leave message.
•
Static router port—When you configure a port as a static router port for a multicast group, all
multicast data for the group received on the port will be forwarded.
To configure static ports:
Step
1. Enter system view.
2. Enter
interface view or Layer 2
aggregate interface view.
Command
system-view
igmp-snooping
router ports
router-aging-time seconds
member ports
host-aging-time seconds
Command
system-view
vlan vlan-id
igmp-snooping
router-aging-time seconds
igmp-snooping
host-aging-time seconds
Command
system-view
Layer 2 Ethernet
interface
interface-number
interface-type
20
Remarks
N/A
N/A
The default setting
seconds.
The default setting
seconds.
Remarks
N/A
N/A
The default setting
seconds.
The default setting
seconds.
Remarks
N/A
N/A
is 260
is 260
is 260
is 260