HP MSR ASM Configuration Manual page 106

Configuration procedure
1. Assign IP addresses and configure unicast routing:
a. Assign an IP address and subnet mask to each interface according to
shown.)
b. Configure OSPF on the routers in the PIM-SM domain to make sure they are interoperable at
the network layer. (Details not shown.)
2. Enable IP multicast routing, PIM-SM, and IGMP:
# Enable IP multicast routing on Router A, enable PIM-SM on each interface, and enable IGMP on
Ethernet 1/1, which connects Router A to the stub network.
<RouterA> system-view
[RouterA] multicast routing-enable
[RouterA] interface ethernet 1/1
[RouterA-Ethernet1/1] igmp enable
[RouterA-Ethernet1/1] pim sm
[RouterA-Ethernet1/1] quit
[RouterA] interface serial 2/0
[RouterA-Serial2/0] pim sm
[RouterA-Serial2/0] quit
[RouterA] interface pos 5/0
[RouterA-Pos5/0] pim sm
[RouterA-Pos5/0] quit
# Enable IP multicast routing, PIM-SM, and IGMP on Router B and Router C in the same way.
(Details not shown.)
# Enable IP multicast routing and PIM-SM on Router D and Router E in the same way. (Details not
shown.)
3. Configure a C-BSR and a C-RP:
# On Router D, configure the service scope of RP advertisements, specify a C-BSR and a C-RP, and
set the hash mask length to 32 and the priority of the C-BSR to 10.
<RouterD> system-view
[RouterD] acl number 2005
[RouterD-acl-basic-2005] rule permit source 225.1.1.0 0.0.0.255
[RouterD-acl-basic-2005] quit
[RouterD] pim
[RouterD-pim] c-bsr pos 5/0 32 10
[RouterD-pim] c-rp pos 5/0 group-policy 2005
[RouterD-pim] quit
# On Router E, configure the service scope of RP advertisements, specify a C-BSR and a C-RP, and
set the hash mask length to 32 and the priority of the C-BSR to 20.
<RouterE> system-view
[RouterE] acl number 2005
[RouterE-acl-basic-2005] rule permit source 225.1.1.0 0.0.0.255
[RouterE-acl-basic-2005] quit
[RouterE] pim
[RouterE-pim] c-bsr pos 5/2 32 20
[RouterE-pim] c-rp pos 5/2 group-policy 2005
[RouterE-pim] quit
94
Figure 32. (Details not