Mld Configuration Examples; Basic Mld Functions Configuration Example - HP MSR ASM Configuration Manual

Task
Remove the dynamic Layer 2 port
entries of a specified MLD group
or all MLD groups.
Clear MLD SSM mappings.

MLD configuration examples

This section provides examples of configuring MLD on routers.

Basic MLD functions configuration example

Network requirements
As shown in
different organizations form stub networks N1 and N2. Host A and Host C are multicast receivers in N1
and N2, respectively.
MLDv1 runs between Router A and N1. MLDv1 runs between the other two routers (Router B and Router
C) and N2. Router B acts as the MLD querier because it has a lower IPv6 address.
The hosts in N1 can only join IPv6 multicast group FF1E::101, and the hosts in N2 can join any IPv6
multicast groups.
Command
reset mld group port-info { all | ipv6-group-address }
[ vlan vlan-id ]
reset mld ssm-mapping group { all | interface
interface-type interface-number { all |
ipv6-group-address [ prefix-length ]
[ ipv6-source-address [ prefix-length ] ] } }
Figure 79, the receivers receive VOD information in the multicast mode. The receivers of
287
Remarks
Available in user
view.
This command
cannot remove
the Layer 2 port
entries of MLD
groups.
Available in user
view.