HP MSR ASM Configuration Manual page 139

Figure 40 Network diagram
Configuration procedure
1. Assign IP addresses and configure unicast routing:
a. Assign an IP address and subnet mask to each interface according to
shown.)
b. Enable OSPF on the routers in the PIM-DM domain to make sure they are interoperable at the
network layer and they can dynamically update their routing information. (Details not shown.)
2. Enable IP multicast routing, and enable PIM-DM and IGMP:
# Enable IP multicast routing on Router B, enable PIM-DM on each interface, and enable IGMP on
Ethernet 1/1.
<RouterB> system-view
[RouterB] multicast routing-enable
[RouterB] interface ethernet 1/1
[RouterB-Ethernet1/1] igmp enable
[RouterB-Ethernet1/1] pim dm
[RouterB-Ethernet1/1] quit
[RouterB] interface ethernet 1/2
[RouterB-Ethernet1/2] pim dm
[RouterB-Ethernet1/2] quit
[RouterB] interface ethernet 1/3
[RouterB-Ethernet1/3] pim dm
[RouterB-Ethernet1/3] quit
# Enable IP multicast routing on Router A, and enable PIM-DM on each interface.
<RouterA> system-view
[RouterA] multicast routing-enable
[RouterA] interface ethernet 1/1
[RouterA-Ethernet1/1] pim dm
[RouterA-Ethernet1/1] quit
127
Figure 40. (Details not