Fuel Tank Inspection; Fuel Tank Purging Procedure; Fuel Tank Inlet Valve Removal And Installation - Suzuki Liana RH413 Service Manual

1
2
6) Install EVAP canister with its bracket (1) to vehicle.
1
7) Install propeller shaft No.2 referring to "Propeller
Shaft Removal and Installation in Section 3D" (if
equipped).
8) Remove muffler referring to "Exhaust Pipe Removal
and Installation in Section 1K".
9) Connect negative cable at battery. With engine OFF,
turn ignition switch to ON position and check for fuel
leaks.

Fuel Tank Inspection

After removing fuel tank, check hoses and pipes
connected to fuel tank for leaks, loose connections,
deterioration or damage. Also check fuel pump
assembly gaskets for leaks, visually inspect fuel tank for
leaks and damage.
Replace any damaged or malconditioned parts.

Fuel Tank Purging Procedure

WARNING
!
This purging procedure will not remove all
fuel vapor.
Do not attempt any repair on tank using heat
of flame as an explosion resulting in personal
injury could occur.
The following procedure is used for purging fuel tank.
1) After removing fuel tank, remove all hoses, pipes,
fuel pump assembly from fuel tank.
3
I3RH0A170005-01
I2RH01170009-01
S3RH0A1706016
S3RH0A1706014
2) Drain all remaining fuel from tank.
3) Move tank to flushing area.
4) Fill tank with warm water or tap water, and agitate
vigorously and drain. Repeat this washing until
inside of tank is clean. Replace tank if its inside is
rusty.
5) Completely flush out remaining water after washing.
CAUTION
!
Never remain water in fuel tank after washing,
or fuel tank inside will get corrosion.

Fuel Tank Inlet Valve Removal and Installation

WARNING
!
Before servicing fuel system, be sure to
observe "Precautions on Fuel System
Service".
Removal
1) Remove fuel tank from vehicle referring to "Fuel
Tank Removal and Installation".
2) Remove clamp and fuel filler hose from fuel tank.
3) Remove fuel tank inlet valve (1) using flat-bladed
screwdriver.
CAUTION
!
Be careful not to damage fuel tank inlet valve
(1) with flat-bladed screwdriver.
Installation
1) Install fuel tank inlet valve (1) to fuel tank and then
install fuel filler hose.
2) Install fuel tank to vehicle referring to "Fuel Tank
Removal and Installation".
Fuel System: 1G-13
S3RH0A1706012
I2RH0B170017-01
I2RH0B170018-01