Pinion Shaft Disassembly And Assembly - Suzuki Liana RH413 Service Manual

14) Check side bearing retainer O-ring (1) for
flawlessness, apply oil to O-ring and then install to
transaxle.
15) Install side bearing retainer (1).
Tightening torque
Side bearing retainer bolt (a): 23 N·m (2.3 kgf-m,
17.0 lb-ft)
NOTE
Install side bearing retainer (1) with its "TOP"
mark (2) facing upward.

Pinion Shaft Disassembly and Assembly

Disassembly
1) Remove shim(s) and then drive out front pinion
bearing (1) by using special tool.
Special tool
(A): 09913–65810
NOTE
Change removed bearing to new one.
2) Remove shim(s) from pinion shaft.
I3RH0A520072-01
I3RH0A520070-01
S3RH0A5206027
(A)
1
I3RH0A520040-01
Manual Transmission/Transaxle:
Assembly
1) Select pinion bearing shim No.1 as follows.
a) Measure length A of drive pinion spacer (1).
b) Using special tool, measure level difference B
between other outer race (1) plus outer race (3)
and inner race (2) of bevel pinion bearing (at
both front and rear).
Level difference at front bearing plus other outer
race: B
Level difference at rear bearing plus other outer
race: B'
Special tool
(A): 09922–77241
c) Measure length C of other outer race (1) using
micrometer.
Level difference at front bearing: B – C = D
Level difference at rear bearing: B' – C = D'
D + D' = E
d) Measure dimension F of differential carrier using
micrometer.
E + F = G
Measured level difference = G – A
5B-44
I3RH0A520049-01
I3RH0A520050-01