Suzuki Liana RH413 Service Manual page 468

4A-10 Brake Control System and Diagnosis:
• For front brake
Special tool
(A): 09956–02311
(B): 09952–36320
(C): 09360–10040 Union bolt as spare part
(D): 09161–10009 Washer as spare part
(F): 55473–82030 Air bleeder plug as a spare
nut
• For rear brake
Special tool
(A): 09956–02311
(E): 09952–36311
(F): 55473–82030 Air bleeder plug as a spare
nut
NOTE
Special tool (B) or (E) is used instead of
thread diameter 10 mm attachment of special
tool (A).
[A]: Front
[B]: Rear
I3RH0A410006-01
1. Air bleeder plug
2. Weight
3) Depress brake pedal gradually till fluid pressure of
front brake becomes as specified below and check
corresponding pressure of rear brake then. It should
be within specification given below.
Front brake
5,000 kPa
50 kg/cm 2
711 psi
4) As done above, apply 100 kg/cm
brake and check that rear brake pressure then is
within specification as given below.
Front brake
10,000 kPa
100 kg/cm 2
1,422 psi
5) If rear brake pressure is not within specification,
adjust it by changing bolt "A" tightening position as
follows.
Tightening torque
LSPV adjust nut (a): 23 N·m (2.3 kgf-m, 17.0 lb-
ft)
• If rear brake pressure is higher than specification,
move bolt "A" rearward and if it is lower, forward.
• Repeat steps 3) – 5) until rear brake pressure is
within specification.
• After adjustment, be sure to torque nut to
specification.
1. LSPV lever 2. LSPV spring
6) Upon completion of fluid pressure test, bleed brake
system and perform brake test.
Rear brake
4,300 – 4,700 kPa
43 – 47 kg/cm 2
611 – 668 psi
pressure to front
2
Rear brake
5,800 – 6,200 kPa
58 – 62 kg/cm 2
825 – 882 psi
I3RH0A410007-01
I3RH0A410008-01
3. LSPV stay