Suzuki Liana RH413 Service Manual page 220

1D-15 Engine Mechanical:
14) Disconnect the following hoses:
Brake booster hose (1)
from intake manifold
Canister purge hose (2)
from EVAP canister
purge valve
Fuel feed and return
hoses from each pipe
15) Remove suspension frame (1) with stabilizer bar and
suspension control arms referring to "Front
Suspension Frame Removal and Installation in
Section 2B".
16) Remove exhaust No.1 and No.2 pipes referring to
"Exhaust Pipe Removal and Installation in Section
1K".
17) Disconnect right and left drive shaft joints from
differential gear referring to "Front Drive Shaft
Assembly Removal and Installation in Section 3A".
For engine and transaxle removal, it is not necessary
to remove drive shafts from steering knuckle.
18) For 4WD vehicle, remove propeller shaft referring to
"Propeller Shaft Removal and Installation in Section
3D".
19) Remove generator referring to "Generator
Dismounting and Remounting in Section 1J".
Heater inlet and outlet hoses
from each pipe
Radiator inlet and outlet
hoses from each pipe
A/T fluid hoses from each
pipe
I2RH0B140042-01
I2RH0B140043-01
20) Remove clutch operation cylinder from transaxle.
(For M/T vehicle)
21) Install lifting device.
22) Remove engine left mounting bolts (1) and engine
right mounting bracket nuts (2).
1
23) Before removing engine with transaxle from body,
recheck to make sure all hoses, electric wires and
cables are disconnected from engine and transaxle.
24) Lower engine with transaxle from body.
NOTE
Before lowering engine, to avoid damage to
P/S pump and/or A/C compressor, raise it
through clearance made on engine
crankshaft pulley side. At this time, use care
so that no excessive force is applied to
hoses.
25) Disconnect transaxle from engine, referring to
"Manual Transaxle Unit Dismounting and
Remounting in Section 5B" or "Automatic Transaxle
Unit Dismounting and Remounting in Section 5A".
26) Remove clutch cover and clutch disk, referring to
"Clutch Cover, Clutch Disc and Flywheel Removal
and Installation in Section 5C".
2
I2RH0B140046-01
I2RH0B140044-01