Suzuki Liana RH413 Service Manual page 385

Installation
1) Install rear knuckle to strut, and connect control rods
and trailing rod to knuckle. At this point, temporarily
tighten them by hand.
2) Tighten strut bracket bolts and nuts to specified
torque.
Tightening torque
Strut bracket nut (a): 90 N·m (9.0 kgf-m, 65.0 lb-
ft)
NOTE
• Strut bracket nut (for 12.9 strength bolt) is
pre-coated with friction stabilizer and
provided with marks indicating the
strength class. Never reuse this nut to
prevent it from loosening. Be sure to
replace nut with a new one whenever
loosening once.
• Be sure to use a bolt and nut in the right
combination which is specified.
3) Apply water tight sealant to mating surfaces of brake
back plate and rear knuckle.
"A": Sealant 99000–31090 (SUZUKI sealing
compound 366E)
[A]: 2WD
I3RH0A230012-01
I3RH01230053-01
[B]: 4WD
4) Install brake back plate and tighten back plate bolts
to specified torque.
Tightening torque
Back plate bolt (b): 50 N·m (5.0 kgf-m, 36.0 lb-ft)
5) For ABS equipped vehicle, check to make sure that
ABS wheel speed sensor tooth is free from any
metal particles and install it to knuckle.
6) Connect brake pipe to wheel cylinder and tighten
brake pipe flare nut (1) to specified torque and install
bleeder plug cap (2) taken off from pipe back to
bleeder plug.
Tightening torque
Brake pipe flare nut (c): 16 N·m (1.6 kgf-m, 12.0
lb-ft)
7) Attach brake hose to strut bracket (3) with E-ring (4)
securely and ABS wheel speed sensor harness
bracket (if equipped).
8) Install wheel hub referring to "Wheel Hub with Wheel
Bearing and Wheel Stud Removal and Installation
(2WD Model)".
9) Install brake drum referring to "Rear Brake Drum
Removal and Installation in Section 4C".
10) Fill reservoir with brake fluid and bleed brake
system. Refer to "Air Bleeding of Brake System in
Section 4A".
Rear Suspension: 2C-21
I2RH01230054-01
I4RH01230016-01