Back Up Lamp Switch Removal and Installation
Removal
1) Disconnect negative cable at battery.
2) Disconnect back up lamp switch coupler (1).
3) Remove back up lamp switch.
1
2. Gear shift and select shaft assembly
Installation
1) Apply oil to new O-ring (1) and tighten back up lamp
switch (2) to specified torque.
Tightening torque
Back up lamp switch (a): 23 N·m (2.3 kgf-m, 17.0
lb-ft)
1
2) Connect back up lamp switch coupler.
3) Connect negative cable at battery.
Back Up Lamp Switch Inspection
S3RH0A5206006
Check backup lamp switch for function using ohmmeter.
Switch ON: Continuity
Switch OFF: No continuity
2
I4RH01520006-01
2, (a)
I3RH0A520006-01
Manual Transmission/Transaxle:
B
A
A: ON
B: OFF
5B-10
S3RH0A5206007
I3RH0A520004-01