Suzuki Liana RH413 Service Manual page 219

6) Remove water pump belt.
7) Drain engine oil, transaxle oil or A/T fluid (for A/T
vehicle) and transfer oil (for 4WD vehicle).
8) Drain coolant referring to "Cooling System Flush and
Refill in Section 1F".
9) Remove air cleaner case and hoses.
10) With hose connected, detach A/C compressor and/
or P/S pump from its bracket (if equipped).
NOTE
Suspend removed A/C compressor and/or P/
S pump at a place where no damage will be
caused during removal and installation of
engine assembly.
11) Disconnect the following electric wires:
TP sensor (1) Generator (8)
MAP sensor (2) Starting motor
ECT sensor Magnet clutch switch of A/C
compressor (if equipped)
CMP sensor Ground terminal (9) from intake
manifold and cylinder block
CKP sensor VSS
Knock sensor Back up light switch (For M/T
vehicle)
Heated oxygen Shift switch (10) (For A/T
sensor vehicle)
EGR valve (3) A/T VSS (11) (For A/T vehicle)
IAC valve (4) NC1 sensor (12)
EVAP canister purge A/T shift solenoid (13) (For A/T
valve (5) vehicle)
Injectors (6) Speedometer sensor
Ignition coil assembly Battery ground cable (14) from
(7) transaxle
Engine oil pressure Each wire harness clamps
switch
12) Remove fuse box from its bracket.
13) Disconnect the following cables.
• Accelerator cable
• Gear select control cable (For M/T vehicle)
• Gear shift control cable (For M/T vehicle)
• Gear select cable (15) (For A/T vehicle)
I2RH0B140025-01
Engine Mechanical: 1D-14
I2RH0B140041-01