Suspension Control Arm / Bushing Disassembly And Assembly; Suspension Control Arm / Steering Knuckle; Check; Suspension Control Arm Bushing Check - Suzuki Liana RH413 Service Manual

Suspension Control Arm / Bushing
Disassembly and Assembly
Disassembly
1) Cut rubber (1) of flange of suspension control arm
front bushing.
2) Using grinder (3), grind off flange (2) of front
bushing.
CAUTION
!
Be careful not to damage suspension control
arm (4) when grinding flange (2) of front
bushing with grinder.
3) Remove front bushing (1) using special tool (A) and
hydraulic press (2).
Special tool
(A): 09913-75821
Assembly
1) Press-fit front bushing (1) by using special tool (C)
S3RH0A2206014
and press (2).
Special tool
(C): 09913-75810
CAUTION
!
Be sure to use new bushing.
NOTE
• Before installing bushing, apply soap
water on its circumference to facilitate
installation.

Suspension Control Arm / Steering Knuckle

Check

Inspect for cracks, deformation or damage.
If defective, replace.
I3RH0A220007-01

Suspension Control Arm Bushing Check

Inspect for damage, wear or deterioration.
If defective, replace.
I2RH01220049-01
Front Suspension: 2B-17
I2RH01220051-01
S3RH0A2206015
I2RH01220005-01
S3RH0A2206016
I4RH01220017-01